IBM N6270 Hardware And Service Manual page 90

13. At the firmware prompt, enter the following command:
14. Select the Normal Boot option from the displayed menu.
15. The next step depends on your system configuration.
16. Copy and install the image from your HTTP server by entering the following
17. Reapply any BIOS or firmware service images that were previously installed
18. Verify that the correct BIOS or firmware service images are installed.
19. The next step depends on your system configuration.
64
IBM System Storage: N6200 Series Hardware and Service Guide
Note: Other parameters might be necessary for your interface. Enter help
ifconfig at the firmware prompt for details.
netboot http://path_to_the_web-accessible_directory/
<release>_netboot.q The system begins to boot, but stops at the Boot menu.
Please choose one of the following:
1) Normal Boot
2) Boot without /etc/rc
3) Change Password
4) Initialize all disks
4a) Same as option 4, but create a flexible root volume
5) Maintenance mode boot
Selection (1-5)? 1
If your system is in...
A stand-alone configuration
An active/active configuration
command:
software update http://path_to_the_web-accessible_directory/
<release>_setup_q.exe -r
on the node by entering the following commands and noting the displayed
information:
version -b
sysconfig
If your system is in...
A stand-alone configuration
An active/active configuration
Then...
Go to the next step.
Give back the node after the boot process is
complete by entering the following
command from the partner console:
cf giveback
Then...
Use the most current versions available for
your system.
Compare the displayed versions from the
target node with the versions installed on
the partner node. If the versions are not the
same, update that target node by installing
the same version of files on the target node
from any applicable service images available
from the IBM N series support website,
which is accessed and navigated as
described in "Websites" on page xxii.