Direct Fax Transmission (Gateway Tx); Pagescope Light - Konica Minolta IF-118 User Manual

Operation Error Messages

Direct Fax Transmission (Gateway TX)

Problem
Data does not
arrive at the
copier.
A fax cannot
be sent from
this copier.

PageScope Light

Problem
A connection
with
PageScope
Light cannot
be
established.
Could not log
in to the
Administrator
mode.
IF-118
Cause
The Unimessage Pro I-Net
Portal settings are incorrect.
Since the size of the received
data is large, it cannot be
received due to the server's
limitations.
The communication mode for
gateway transmissions is
incorrectly specified.
Cause
The IP address for the device
is not specified correctly.
The URL setting in the Web
browser is incorrect.
The settings in the Web
browser are incorrect.
If a proxy is specified with the
browser and the IP address of
this copier cannot be
recognized by the proxy
server, the PageScope Light
window cannot be display.
The LAN cable is damaged.
Before logging in this time, a
different user name and
password had been entered to
log in.
Remedy
Check the Unimessage Pro I-
Net Portal settings.
Reduce the size of the data,
for example, by decreasing
the number of pages, and then
try sending again.
The network setting
"GATEWAY TX" must be set
to "ENABLE", and the
communication mode must be
set correctly.
Remedy
Specify the IP address.
In the "Address" box, type the
IP address of the specified
device.
Even though the device can
be accessed, certain settings
must be specified according to
the network configuration in
order to establish a
connection. For details,
contact your network
administrator.
Use the proxy settings in the
browser to add the IP address
of this copier to the list of
exceptions that the proxy
server will not use.
Replace the LAN cable.
Once login is successful, that
user name and password is
saved in the browser until the
browser is closed. Close the
browser, and then start it up
again.
9
Page
referen
ce
Unimes
sage
Pro I-
Net
Portal
User
Manual
-
p. 3-11
Page
referen
ce
p. 3-8
p. 2-15
-
-
-
-
9-5