D-Link DES-3226L Reference Manual page 133

DES-3226L Layer 2 Fast Ethernet Switch User's Guide
show bandwidth_control
Purpose Used to display the bandwidth control
configuration on the switch.
Syntax show bandwidth_control {<portlist>}
Description The show bandwidth_control command
displays the current bandwidth control
configuration on the switch, on a port-by-
port basis.
Parameters <portlist> − Specifies a range of ports to be
configured. The port list is specified by
listing the lowest switch number and the
beginning port number on that switch,
separated by a colon. Then the highest
switch number, and the highest port
number of the range (also separated by a
colon) are specified. The beginning and end
of the port list range are separated by a
dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch
number 2, port 4. 1:3-2:4 specifies all of
the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order.
If no parameter is specified, the system will
display all ports bandwidth configuration.
Restrictions None.
Example usage:
To display bandwidth control settings:
133