wsm RC60-27BR Workshop Manual page 53

RCK54/60-24B-EC · RCK60-27B-EC · RC60-24/27BR, WSM
(A)
Outer Pulley and Blade Shaft
1. Unscrew the outer pulley mounting nut (18), and remove the
outer pulley (21) and feather key (26).
2. Unscrew the pulley holder mounting screws (22), and separate
the left pulley holder (24) from the mower deck.
3. Remove the external snap ring (32) on the left blade shaft (27).
4. Remove the blade boss (31) and oil seal (30).
5. Remove the internal snap ring (29) and tap out the left blade shaft
(27) with ball bearings (25), (28), taking care not to damage the
grease nipple (17).
6. Remove the oil seal (23).
7. Remove the ball bearings (25), (28) from the blade shaft (27).
8. Remove the right pulley holder (8) and blade shaft (11) as above.
NOTE
• The collar (33) adapts to RC60-24BR only.
(When reassembling)
• Replace the oil seals (30), (23), (14), (6) with new ones.
Outer pulley mounting nut
Tightening torque
Pulley holder mounting
screw
(1) Grease Nipple
(2) Outer Pulley Mounting Nut
(3) Spring Washer
(4) Plain Washer
(5) Outer Pulley (Right)
(6) Oil Seal
(7) Pulley Holder Mounting Screw
(8) Pulley Holder (Right)
(9) Ball Bearing
(10) Feather Key
(11) Blade Shaft (Right)
(12) Ball Bearing
(13) Internal Snap Ring
(14) Oil Seal
(15) Blade Boss
(16) External Snap Ring
(17) Grease Nipple
(18) Outer Pulley Mounting Nut
S-15
ROTARY MOWER
166.7 to 186.3 N·m
17.0 to 19.0 kgf·m
123.0 to 137.4 ft-lbs
77.4 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
(19) Spring Washer
(20) Plain Washer
(21) Outer Pulley (Left)
(22) Pulley Holder Mounting Screw
(23) Oil Seal
(24) Pulley Holder (Left)
(25) Ball Bearing
(26) Feather Key
(27) Blade Shaft (Left)
(28) Ball Bearing
(29) Internal Snap Ring
(30) Oil Seal
(31) Blade Boss
(32) External Snap Ring
(33) Collar
(A) RC60-24BR
(B) RC60-27BR
W1019310
KiSC issued 11, 2006 A