wsm RC60-27BR Workshop Manual page 31

RCK54/60-24B-EC · RCK60-27B-EC · RC60-24/27BR, WSM
Adjusting Front Link (Lift Cylinder Type)
CAUTION
• Before starting engine, make sure that all levers (including
auxiliary hydraulic control lever) are in neutral position.
• Shut off the engine and allow the mower blades to stop
before making adjustment.
1. Park the tractor on a firm, flat and level surface.
2. Raise the mower and set the height of mower gauge wheels the
same.
3. Lower the mower to the ground.
4. If the gauge wheels are not on the ground, remove the front link
from the mower. And adjust the length (L) of the front link (1) until
the gauge wheels come into contact with the ground.
5. Attach the front link to the mower.
6. Start the engine.
7. Operate the auxiliary hydraulic control lever rearward to rise the
mower.
8. Stop the engine then check whether the mower is level. If the
mower is not level, lower the mower to the ground and adjust the
clevis (2).
IMPORTANT
• Tire pressure must be correct.
(1) Front Link
(2) Clevis
G-20
G GENERAL
(A) RCK54-24B-EC, RCK60-24B-EC,
RCK60-27B-EC
(B) RC60-24BR, RC60-27BR
W1018742
KiSC issued 11, 2006 A