wsm RC60-27BR Workshop Manual page 24

RCK54/60-24B-EC · RCK60-27B-EC · RC60-24/27BR, WSM
Mid Hanger Bracket
1. Screw M12 stud bolts (1) in the clutch housing.
2. Attach the mid hanger brackets (2) to the clutch housing with
spring washers and nuts.
Stud bolt
Tightening torque
Nut
(1) Stud Bolt
(2) Mid Hanger Bracket
Rear Hanger Bracket (Lift Cylinder Type)
B1710, B2110 and B2410
1. Assemble the lift cylinder kit as shown in figure.
2. Apply grease to the cylinder joint pin (4), (5) and lift shaft (1).
3. Apply seal tape to the cylinder adaptor (2) and set the direction
as shown in figure.
Tighten the cylinder adaptor with specified torque then rotate
(clockwise) the adaptor to set the specified direction.
4. Set the cylinder rod flat face toward the RH side of machine.
Tightening torque Cylinder adaptor
(1) Lift Shaft
(2) Cylinder Adaptor
(3) Cylinder
(4) Joint Pin
(5) Joint Pin
G-13
G GENERAL
31.4 N·m
3.2 kgf·m
23.1 ft-lbs
68.6 N·m
7.0 kgf·m
50.6 ft-lbs
(A) Outside (Round End)
(B) Inside (Flat End)
(C) Thread Size : M12 x Pitch 1.25
(D) Thread Size : M12 x Pitch 1.75
(E) RCK54-24B-EC, RCK60-24B-EC,
RC60-24BR
(F) RCK60-27B-EC, RC60-27BR
W1029421
24.5 N·m
2.5 kgf·m
18.1 ft-lbs
A : 1.57 rad. (90 °)
W1015981
KiSC issued 11, 2006 A