General Precaution - wsm RC60-27BR Workshop Manual

RCK54/60-24B-EC · RCK60-27B-EC · RC60-24/27BR, WSM

2. GENERAL PRECAUTION

• During disassembly, carefully arrange removed parts in a clean
area to prevent confusion later. Screws, bolts and nuts should be
installed in their original position to prevent reassembly errors.
• When special tools are required, use KUBOTA genuine special
tools. Special tools which are not frequently used should be
made according to the drawings provided.
• Use KUBOTA genuine parts or KUBOTA-recommended parts
and lubricants or their equivalents.
• Gaskets and o-rings must be replaced during reassembly.
• Apply grease to new o-rings or oil seals before assembling. See
the figure.
• When reassembling external snap rings or internal snap rings,
they must be positioned so that sharp edge faces against the
direction from which a force is applied. See the figure.
• Metric screws, bolts and nuts are not interchangeable with
nonmetric fasteners.
• Remove oil and dirt from parts before measuring.
(1) Grease
(2) Force
(3) Sharp Edge
G-2
G GENERAL
(A) Oil Seal
(B) External Snap Ring
(C) Internal Snap Ring
W1020761
KiSC issued 11, 2006 A