wsm RC60-27BR Workshop Manual page 43

RCK54/60-24B-EC · RCK60-27B-EC · RC60-24/27BR, WSM
Adjusting Cutting Height (Side Discharge Mower)
1. The cutting height can be adjusted from 38 mm to 102 mm (from
1.5 in. to 4.0 in.).
2. To adjust the cutting height, lift the mower slightly and close the
3-point lowering speed knob (1).
3. Adjust the cutting height with the front gauge wheels, rear gauge
wheel, anti-scalp wheel and anti-scalp rollers as shown in the
table below.
The recommend cutting height is approx. 50 mm (2.0 in.).
[RCK54-24B-EC, RCK60-24B-EC, RCK60-27B-EC]
Front gauge
Cutting height
wheel
35 mm (1.5 in.) C-X
51 mm (2.0 in.) C-Y
64 mm (2.5 in.) B-X
76 mm (3.0 in.) B-Y
89 mm (3.5 in.) A-X
102 mm (4.0 in.) A-Y
IMPORTANT
• After adjusting the cutting height, open the 3-point lowering
speed knob (1) and adjust the lowering speed of the mower.
(1) 3-point Lowering Speed Knob
S-5
ROTARY MOWER
Rear gauge Anti-scalp Anti-scalp
wheel wheel
1
a-x
2
3
b-x
4
5
c-x
6
KiSC issued 11, 2006 A
roller
I
II
III
W1011439