Record And Snapshot; Encode - Dahua NVR6000 series User Manual

In Figure 3-34, input tour value and then click
Call Scan
In Figure 3-34, input Scan value and then click
Rotate
In Figure 3-34, click
System supports preset, tour, pattern, scan, rotate, light and etc function.
Note:

Preset, tour and pattern all need the value to be the control parameters. You can define it as you
require.

You need to refer to your camera user's manual for Aux definition. In some cases, it can be used for
special process.
Aux
Click , system goes to the following interface. The options here are defined by the protocol. The aux
number is corresponding to the aux on-off button of the decoder. See Figure 3-40.

3.7 Record and Snapshot

The record/snapshot priority is: Alarm->Motion detect->Schedule.

3.7.1 Encode

3.7.1.1 Encode
Encode setting is to set IPC encode mode, resolution, bit stream type and etc.
From Main menu->Setting->System->Encode, you can see the following interface. See Figure 3-41.
to enable the camera to rotate.
Figure 3-40
to call a tour. Click again
to call a tour. Click again
to stop call.
to stop call.
56