Record And Snapshot; Encode - Dahua NVR6032K User Manual

In Figure 3-34, input tour value and then click
Call Scan
In Figure 3-34, input Scan value and then click
Rotate
In Figure 3-34, click
System supports preset, tour, pattern, scan, rotate, light and etc function.
Note:

Preset, tour and pattern all need the value to be the control parameters. You can define it as you
require.
You need to refer to your camera user's manual for Aux definition. In some cases, it can be used for

special process.
Aux
Click , system goes to the following interface. The options here are defined by the protocol. The aux
number is corresponding to the aux on-off button of the decoder. See Figure 3-40.

3.7 Record and Snapshot

The record/snapshot priority is: Alarm->Motion detect->Schedule.

3.7.1 Encode

3.7.1.1 Encode
Encode setting is to set IPC encode mode, resolution, bit stream type and etc.
From Main menu->Setting->System->Encode, you can see the following interface. See Figure 3-41.
to enable the camera to rotate.
Figure 3-40
to call a tour. Click again
to call a tour. Click again
to stop call.
to stop call.
37