Cluster Control; Dcs Log - Dahua NVR6000 series User Manual

. is the resume button.
Important
If you want to switch the slave device to the main device, please click
main device. You can see the following prompt. See Figure 4-109.
After the master device becomes active again, system can forward the record files on the slave device
to the master device.

4.8.6.4 Cluster control

From main menu->Setup->Cluster service->Cluster control, you can go to the cluster control interface.
It is to enable/disable cluster. See Figure 4-110.
You can see the corresponding prompt if you successfully enabled cluster service.

4.8.6.5 DCS Log

From main menu->Setup->Cluster service->DCS log, you can go to the DCS log interface.
The DCS log interface is shown as in Figure 4-111. Here you can search and view the DCS log.
Figure 4-109
Figure 4-110
button manually to resume the
206