Alarm Output; Storage; Schedule - Dahua NVR6000 series User Manual

Parameter
Alarm Out
Latch
Show
message
Alarm
upload
Send
Email
Buzzer

4.8.3.6 Alarm Output

From main menu-> Setup->Event->Alarm output, it is to set alarm output mode. See Figure 4-71.

4.8.4 Storage

4.8.4.1 Schedule

From main menu-> Setup->Storage->Schedule, you can go to the schedule interface. In this interfaces,
you can add or remove the schedule record setup. See Figure 4-72.
There are five record modes: Regular, motion detect, alarm and MD&alarm, and intelligence. There are
six periods in one day.
You can view the current time period setup from the color bar.

Green color stands for the general record/snapshot.

Yellow color stands for the motion detect record/snapshot.

Red color stands for the alarm record/snapshot.

Blue color stands for MD&alarm record/snapshot.

Orange color stands for intelligent record/snapshot.
Function
Please select corresponding alarm output channel when an alarm
occurs. You need to check the box to enable this function.
The alarm output can delay for the specified time after an alarm stops.
The value ranges from 1s to 300s.
System can pop up a message to alarm you in the local host screen if
you enabled this function.
System can upload the alarm signal to the centre (Including alarm
centre.
If you enabled this function, System can send out an email to alert you
when an alarm occurs.
Check the box here to enable this function. The buzzer beeps when an
alarm occurs.
Figure 4-71
184