General Problems Of Printing - Konica Minolta bizhub pro 1200P User Manual

Troubleshooting
11.2

General Problems of Printing

The image controller does not respond to the Print command.
1
Check that the printing system is selected as the current printer.
– The printing system must be selected as the current printer on Win-
dows before printing.
2
Check that the power switch of the copier is turned on.
3
Print the Test Page from Windows/Macintosh.
– When you cannot print a job from an application even though you
can print a test print, contact a system administrator or a service
representative.
4
If the message "Error" is displayed, check that the control panel is in
copy mode, not scanner mode.
Cannot select any media other than [Plain Paper] from [Paper Type].
1
For the PCL Driver, select [Default] from the [Basic] tab or [Cover Mode]
tab to restore the default setting.
2
Set [Paper Tray] to a setting other than [Auto].
A message requesting a paper size you did not specify is displayed.
1
Cancel the job to change the paper size in the "Page (Paper) Setup" di-
alog on your application.
2
Touch and select the desired size displayed in the paper sizes area of
the control panel, then press [START]. The forced output will start.
You cannot print the test print.
1
Check the LCD of the main body printer control panel.
– When "Ready to copy" is displayed on the LCD, go to Step 3.
– When a diagnostic message or an error message is displayed on
the LCD, refer to the "User's Guide (Copier or Main Body)".
– When the LCD is blank, go to Step 2.
2
Press [POWER SAVER ON/OFF] on the control panel.
– When the main body printer is used in the Power Save mode, press
this switch to show the LCD in the Display mode.
bizhub PRO 1200/1200P/1051 Printer
11
11-2