Updates For The Hp Switch Software Ipv6 Configuration Guide; Access Control Lists (Acls); Introduction - HP 2530 Manual Supplement

2 Updates for the HP Switch Software IPv6 Configuration
Guide

Access Control Lists (ACLs)

Fix or Feature update?
Feature update: Access
Control Lists (ACLs)
NOTE: IPv6 ACLS and RADIUS ACLs are not supported on the following HP switches: J9779A,
J9780A, J9782A, and J9783A.

Introduction

An Access Control List (ACL) contains one or more Access Control Entries (ACEs) specifying the
criteria the switch uses to either permit (forward) or deny (drop) IP packets traversing the switch's
interfaces.
This chapter describes how to configure, apply, and edit static IPv6 ACLs for filtering IPv6 traffic
in a network populated with the switches covered by this guide, and how to monitor IPv6 ACL
actions.
NOTE:
Because the switches covered by this guide operate in IPv4/IPv6 dual stack mode, IPv4 and IPv6
ACLs can operate simultaneously in these switches with the restrictions listed below:
Static IPv6 ACLs and IPv4 ACLs do not filter each other's traffic.
IPv6 and IPv4 ACEs cannot be configured in the same static ACL.
See "RADIUS-assigned ACLs" (page
RADIUS-assigned ACLs can be configured to filter either IPv4 traffic only, or both IPv4 and
IPv6 traffic.
In this chapter, unless other wise noted:
The term "ACL" refers to IPv6 ACLs.
Descriptions of ACL operation apply only to IPv6 traffic.
For information on configuring and applying static IPv4 ACLs, see the "IPv4 Access Control Lists
(ACLs)" chapter in the HP Switch Software Access Security Guide for your switch.
Feature
Numbered ACLs
Standard ACLs
Extended ACLs
Named ACLs
Enable or Disable an ACL
Display ACL Data
Delete an ACL
Software Release Affected Chapter/Section
Available for software The following content replaces Chapter 5— Access Control
release YA.15.13 and Lists (ACLs) in the HP Switch Software IPv6 Configuration
later. Guide.
58).
Default CLI
None 59
None 60
80
82
n/a 82
n/a 87
Access Control Lists (ACLs) 57