Page of 5
   
HP 1410 Switch Quick Setup Guide
The switch images in this document are for illustration only and may not match your particular switch model.
For detailed information to set up your switch, view or download the Installation and Getting Started Guide for your switch
at www.hp.com/networking/support.
1.
Unpack and check included parts.
2.
Prepare for installation. To avoid personal injury or product damage, review the "Safety Precautions" on
page 3.
3
. Connect power and verify that the switch power LED turns on. The switch does not contain a power switch. It is
turned on by connecting power through the AC power adapter supplied with your switch.
1
Power LED = On
4.
Install the Switch Hardware. Turn off the switch before installing the switch hardware.
Table or Desktop: Attach the four self-adhesive pads
(included in the accessory kit) to the bottom corners of
the switch.
3
2
Documentation kit
The switch
Accessory kit (installation hardware)
AC power adapter (and power cord, if applicable)
1
1
2

Advertising

   Also See for HP 1410

   Related Manuals for HP 1410

   Summary of Contents for HP 1410

  • Page 1

    HP 1410 Switch Quick Setup Guide The switch images in this document are for illustration only and may not match your particular switch model. For detailed information to set up your switch, view or download the Installation and Getting Started Guide for your switch at www.hp.com/networking/support.

  • Page 2

    Install the Switch Hardware (Continued) M-4 tap Wall (or Under-Table): A hardware kit for wall-mounting (or screws under-table mounting) is included. Use a #1 Phillips (cross- head) screwdriver and the 20-mm M4 tap screws (included). For screw positions, see the mounting hole dimensions on page 4.

  • Page 3: Safety Precautions

    Ensure the air flow around the switch is not restricted. Leave at least 7.6 cm (3 inches) for cooling. For other available ■ air flow information, see the Installation and Getting Started Guide for your product, located on the HP Web site at www.hp.com/networking/support.

  • Page 4

    (Under-table mounting) After installation, prevent switch movement by placing a third screw along this side. Table 1. Mounting Hole Dimensions Switch Model Hole-to-Hole Dimension 1410-8 3.54 inch (90.0 mm) 1410-16 5.91 inch (150.0 mm) 1410-24 5.91 inch (150.0 mm) 1410-24-2G 5.91 inch (150.0 mm)

  • Page 5

    Printed in China © Copyright 2011 Hewlett-Packard Development Company, L.P. January 2011 The information contained herein is subject to change without notice. 5998-0937 *5998-0937*...

Comments to this Manuals

Symbols: 0
Latest comments: