Displaying Content Of All Acls On The Switch - HP 2530 Manual Supplement

Example 40 Summary table of access lists
HP Switch(config)# show access-list
Access Control Lists
Type Appl Name
----- ---- ------------------------
ext yes 101
std yes 55
ext yes Marketing
ipv6 no
ipv6 no
ipv6 yes List-02-Outbound
ipv6 yes Test-1
IPv4
1
1
1
Term Meaning
Type Show whether the listed ACL is an IPv6 (ipv6) ACL or one of two IPv4 ACL types:
Appl Show whether the listed ACL has been applied to an interface (yes/no).
Name Show the identifier assigned to each ACL configured in the switch.

Displaying content of all ACLs on the switch

The show access-list command provides configuration details for every ACL configured in
the running-config file, whether or not you have assigned any to filter traffic on switch interfaces.
Syntax:
show access-list config
List the configured syntax for all ACLs currently configured on the switch.
NOTE: You can use the output from this command for input to an offline text file where you can
edit, add, or delete ACL commands. See
This information also appears in the show running display. If you execute write memory after
configuring an ACL, it appears in the show config output.
For example, with two ACLs configured in the switch, you will see results similar to the
followingExample 41 "An ACL configured syntax
96 Updates for the HP Switch Software IPv6 Configuration Guide
1
2
3
Accounting 4
List-01-Inbound 5
std (Standard; source-address only)
ext (Extended; protocol, source, and destination data)
These ACLs exist in the configuration but are
4
not applied to any interfaces and thus do not
5
affect traffic.
"Creating or editing an ACL offline" (page
listing":
102).