Table of Contents
Advertisement
6.
Assign a unique IP (multicast) address to the Tuner:
a.
Select Tuner A Setup to access the Tuner A Setup page.
b.
Enter a unique IP address for Tuner A in the Tuner Output/IP Address field, and click Save.
A IPv4 multicast address should be used, ranging from 224.0.0.0 to
239.255.255.255. Avoid any reserved addresses.
6) Configure the Receiver(s)
The basic steps outlined below apply to each Receiver in the system.
1.
Click the Rx Setup command button to open the Receiver Setup (Network Settings) page (see the
Receiver Setup Pages section on page 66).
After booting up a Rx (or Tx), it must first be allocated an IP address (if DHCP
enabled) before appearing in the device list. Depending on the Network, this may
take a couple of minutes.
2.
Rename each Receiver, so that you can identify them easily in the future.
a.
Select a Receiver in the Manage Unit list.
b.
Enter a new name for the selected Receiver in the Unit Name text field.
c.
Click Update.
3.
Enable Channels on the selected Receiver:
a.
Click Channel Setup to open the Receiver Setup - Channel Settings page.
b.
Select the channels that you want to receive on the selected Receiver.
c.
Click Save.
Scaling and Centering the Picture
If the picture needs to be scaled or centered:
1.
Disconnect the Receiver from the network and reboot.
2.
Press MENU on the remote to display the menu page on the monitor.
3.
The Player Setup options allow the user to adjust display scale and position.
Assigning a DTV-RC01 Remote Controller To a Specific Receiver
1.
In the Digital TV Configuration Manager (see the Digital TV Configuration Manager section on
page 53), enter a 2-digit numeral/character combo (any combination of 0-9 and A-F), in the Remote
Control Number field of the Receiver Setup - Output Settings page (FIG. 71).
FIG. 71
Receiver Setup - IR Settings
See the Receiver Setup - Output Settings (DTV-RX02-HD) section on page 69 for
more information.
2.
Click Save to load the new remote control address into the Receiver.
AMX TDS (Television Delivery System)
The Receivers are listed under Manage Unit in the Receiver Setup - Network Settings page, each
one indicated by it's MAC address. The MAC address for each Receiver is printed on a label
located on the bottom panel of the device.
If you do not see the installed Receivers indicated in this list, refresh your browser window.
Select All Units to apply the channel selection on this page to all Receivers in the system.
The default Remote Control Number for DTV-RC01 remote controllers is 6E.
AMX TDS Installation Overview
51
Advertisement
Table of Contents
