Table of Contents
Advertisement
DTV-MA01 TDS Management Appliance
FIG. 64 diagrams the pinouts and signals for the 10/100 Port RJ45 connector and cable. Note that while 568B
termination is shown in the figure, 568A can also be used, as long as both ends are terminated the same way.
FIG. 64
RJ45 wiring diagram
Consult the Network Administrator for correct cabling from the DTV-MA01 onto the network.
Ethernet LEDs
L/A - Link/Activity LED
lights (green) when the
Ethernet cables are
connected and terminated
FIG. 65
Ethernet LEDs
Default IP Address
By default, the DTV-MA01 is set to DHCP.
The DTV-MA01 must be set to a static IP address, or have the DHCP server set
up to always give it the same IP address. Automatic re-assignment of the IP
address via DHCP may cause communication issues with the TDS system. If the
DTV-MA01 is assigned a new IP address, then all TX and RX units in the system
must be rebooted.
Network Switch Requirements
The DTV-MA01 requires a Layer 3 Gigabit Switch with multicast support, IGMP Querier/Snooping and PIM.
Audio Output Connector
The green 1/8" stereo connector provides analog audio output (FIG. 66). Note that the Audio in (blue) and
Microphone (red) connectors are not used.
FIG. 66
Analog Audio Output
44
For remote connectivity, the Firewall may have to be configured to open port 2008 for remote
connectivity over UDP.
Ports 5000 and 5001 are required for the Transmitters as well as any ports used for the TDS
Multicast stream.
Ports 5002 and 5003 are fixed as the multicast stream output ports.
correctly.
SPD - Speed LED
lights (yellow) when the
connection speed is 100 Mbps
and turns Off when speed is
10 Mbps.
AMX TDS (Television Delivery System)
Analog Audio Output
Advertisement
Table of Contents
