Table of Contents
Advertisement
Product Specifications
DTV-TX01-DVB-T Transmitter
Dimensions (HWD):
Weight:
Power Requirements:
Tuners:
RF Input Level:
Front Panel Components
• NETWORK Connector:
• LEDs:
• Common Interface
Slots 1 & 2:
• RESET button:
Rear Panel Components:
• RF INPUTs:
• RF OUTPUTs:
• Factory Reset Button:
• SERIAL (RS232):
• PWR:
Environment:
Certifications:
Other AMX Equipment:
AMX TDS (Television Delivery System)
AMX TDS - Terrestrial/Satellite (Standard Definition)
2.18" x 5.41" x 7.60" (5.56cm x13.74cm x 19.30cm)
2.75 lbs (1.25 kg)
• Power Consumption: 6W
• Voltage rating: nominal 12 to 13.5V DC
• Current draw at 12V: 0.5A
2 internal tuners
• 480 ˜ 860 MHz
• -35 ˜ -50 dBm
Standard RJ45 connector.
Three LEDs indicate the status of the Transmitter:
• Streaming LED (green): Flashes if only one tuner is streaming. Steady on if both
tuners are streaming.
• Network Connectivity LED (green): Lights to indicate that the Transmitter is
connected and communicating with the network.
• Power status LED (yellow): Lights to indicate that the Transmitter is receiving
power, and is functional.
Dual Common Interface Slots enable the Transmitter to select encrypted channels
in cases where this is supported by the broadcaster.
Note: Before de-scrambling content using the Common Interface Slots, ensure that
you have the appropriate authority/rights to transmit the de-scrambled content on
your network.
Press to reboot the Transmitter.
Two TV aerial plug/Belling-Lee connectors accept incoming terrestrial signals.
Two RF aerial plug/Belling-Lee connectors allow you to daisy chain
DTV-TX01-DVB Transmitters together.
Note: There is a 3db signal loss on RF output relative to the RF input.
The recessed Factory Reset button on the rear panel allows you to perform a full
factory reset (resets flash and reboots the Transmitter in DHCP mode):
• Press and hold the recessed Factory Reset button while simultaneously pressing
the Reset button on the front panel.
• Continue to hold the Factory Reset button while the unit is rebooting.
• Release when the Streaming Status LED begins to flash.
DB9 serial connector for local command line interface (RS232 only).
2-pin mini-phoenix connector provides 12VDC power from the power supply.
Note: A 12VDC Power Supply is required (not included)
• Operating Temperature: 32°F - 122°F (0°C to 50°C)
• Operating Humidity: Max. relative humidity - 85% (non-condensing)
• CE
• FCC part 15 Class A
• DTV-MA01 TDS Management Appliance (FG1412-01)
• DTV-RX01-SD Receiver (FG1411-01)
• DTV-TX02-DVB-S Transmitter (FG1410-02)
• DTV-RK, Rack Mount Kit for DVB-T/S Transmitters (FG1410-60)
• CC-232 Serial Communication Cable (FG10-752-04)
• 12V Power Supply
21
Advertisement
Table of Contents
