Table of Contents
Advertisement
Serial Commands
ClearQAM/ATSC (High Definition) Serial Commands (Cont.)
setip wlan Following prompts to configure WIFI network settings. This setting takes effect immediately after
setip clear Clear the current setting in "setip lan" option. This does not affect the current network
Terrestrial/Satellite (Standard Definition) Serial Commands
The following serial commands are supported by both DTV-TX Transmitters and DTV-TX Receivers:
Terrestrial/Satellite (Standard Definition) Serial Commands
DHCPd,i.i.i.i,gw.gw.gw.gw,
nm.nm.nm.nm
IP?
STATUS
(Transmitters)
80
the unit boots up.
Enter DHCP option (0/1) >
Enter wlanIpAddr:
Enter wlanSubnet:
Enter wlanGateway:
Enter wlanPriDNS:
Enter wlanSecDNS:
Enter DomainName:
Enter SSID:
WEP Type (0-4): 0[None]/1[WEP40]/2[WEP128]/3[WPA]4[WPA2]
(Follow prompts to enter WEP keys)
configuration.
Sets IP details:
• ip = ip
• gw = gateway
• nm = network mask
Note: All DTV Transmitters and Receivers must have an assigned IP Address,
Network Mask, and Gateway Address in order for the DTV system to work
correctly. This applies to units that utilize DHCP and to units that have been
assigned Static IP addresses. If you are using DHCP, verify that these address
assignments are provided by the DHCP Server.
Unit responds with a summary of status network settings:
• DHCP status
• MAC
• IP address
• Gateway
• Netmask
Responds with unit status information, in the format:
STATUS a b c d e f g h
Example:
STATUS 1 224.10.0.3:1234 1:1:c3:[6000:64c0 6000:6440]
F:DVB-T E:0 C:"NO CAM"
where:
• A = Unit command (0,1 or 2 for transmitter)
• B = transport stream IP,Port,tttt,pppp
• C:D = Full mode (1 - full, 0 - not full):
• D = Streaming mode (1- locked, 0 - not locked)
• E = Signal strength (in real time)
• F = programs being streamed
• G = Frontend - Type of Tx it is (DVB-T, S or cable)
• H = whether the signal is encrypted
• I = whether the CAM is being used
• J = The number of PIDs being used
AMX TDS (Television Delivery System)
Advertisement
Table of Contents
