Connecting an IR Emitter
1.
Connect an IR01 IR Emitter cable (FG-IR01) to the IR Tx port on the DTV Receiver.
2.
Run the other end of the IRTX cable to the display device and locate the IR window.
3.
Attach the IR Emitter bud over the device's IR sensor by removing the cover of the reverse side of the
Emitter and sticking it directly over the IR window.
Rear Panel - Reset Pushbutton
Press to the Reset Pushbutton on the rear panel to reboot the Receiver (FIG. 47).
FIG. 47
Reset Pushbutton
The RESET pushbutton is used in conjunction with the recessed Factory Reset
button on the front panel to perform a full factory reset of the Receiver. See the
Performing a Full Factory Reset on the DTV-RX01-SD Receiver section on page 35
for details.
Rear Panel - Status LEDs
There are three LEDs on the rear panel to indicate various types of device status (FIG. 48):
FIG. 48
Status LEDs
Rear Panel - Audio Output Connectors
The Audio Output connectors are grouped under "AUDIO" on the rear panel (FIG. 49):
FIG. 49
Audio Output Connectors
AMX TDS (Television Delivery System)
Reset Pushbutton
Power
Streaming
Power (red): Lights to indicate that the Receiver is receiving power (via PoE), and is functional.
Streaming (yellow): Flashes to indicate that the Receiver is receiving or sending data from or to the
master.
Lock (green): Lights to indicate that the Receiver is locked to a transport stream, and should be
playing video/audio (if valid channel is selected).
RCA Stereo cable
Analog: Standard red and white AUDIO RCA connectors provide analog stereo audio output
(White = Left, Red = Right).
Digital: The Black SPDIF RCA connector provides digital audio output.
AMX TDS - Terrestrial/Satellite (Standard Definition)
Lock
Digital Stereo cable
33