Table of Contents
Advertisement
Rear Panel - RF IN 1 & 2
The RF IN 1 & 2 connectors accept incoming digital TV signals via a standard coaxial input.
Incoming Digital TV Signal
(up to 2 per DTV Transmitter)
FIG. 40
DTV-TX01-DVB-T Transmitter - RF IN 1/2
These connectors can also be used to accept incoming signals from another upstream Transmitter, in
installations with multiple Transmitters (see FIG. 41 on page 27).
Refer to the following sections for more information:
Rear Panel - RF OUT 1 & 2 (DTV-TX01-DVB-T only)
The RF OUT 1 & 2 aerial plug/Belling-Lee connectors (on the DTV-TX01-DVB-T only) allow you to daisy
chain DTV-TX01-DVB-T Transmitters together. Use these connectors to send the TV signal coming into the
RF IN 1 & 2 connectors to other downstream DTV-TX01-DVB-T Transmitters (FIG. 41).
RF-2
INPUT
RF OUT 1
RF-1
INPUT
FIG. 41
DTV-TX01-xx Transmitter
Each time an RF feed is output from a Transmitter and fed back into another
downstream Transmitter (as an RF input), the signal strength will be lower -
approximately a 3dB drop in signal level for each split in signal.
Rear Panel - Factory RESET Button
The recessed Factory Reset button on the rear panel allows you to perform a full factory reset (resets flash and
reboots the Transmitter in DHCP mode):
1.
Press and hold the recessed Factory Reset button while simultaneously pressing the Reset button on the
front panel.
2.
Continue to hold the Factory Reset button while the unit is rebooting.
3.
Release when the Streaming Status LED (see FIG. 36 on page 25) begins to flash.
AMX TDS (Television Delivery System)
RF IN 2
RF IN 1
Connecting a Terrestrial Source to DTV-TX01-DVB-T Transmitters section on page 37.
Connecting a Satellite Source to DTV-TX02-DVB-S Transmitters section on page 38.
RF IN 1
Coax
AMX TDS - Terrestrial/Satellite (Standard Definition)
Video is distributed via
Ethernet to DTV Receiver(s)
RF OUT 1
RF IN 1
Coax
Video is distributed via
Ethernet to DTV Receiver(s)
27
Advertisement
Table of Contents
