Setup Mode And Patch Programming; Programming Mode Entry; Setup Mode - Peak FCB8N Owner's Manual

SETUP MODE AND PATCH PROGRAMMING

Programming Mode Entry

On power-up the FC8BN defaults to operating mode. To change to edit mode:
1. Select the PATCH that you want to configure by using the BANK and PATCH switchs.
2. Press both BANK UP
BANK/PROGRAM
(The BANK/PROGRAM
3. Release the
4. The BANK/PROGRAM
5. Flashing LED's indicate programming menu functions that are available for editing. Refer to
the text below the flashing LED's.
6. Press the associated switch to enter the required programming menu.
Programming menus are:
mode and return to operating mode by pressing the

Setup Mode

Configure the FCB8N to operate in 4Pr mode or 12Pr mode or adjust LED display contrast:
1. Enter Programming Mode.
2. When in Programming Mode press the
show the following:
3. All Programming Menu LED's will be off and the
are in Setup mode. To see associated sub-menus please press and hold
4. Scroll up and down the sub-menus by pressing
<<PREV to see previous sub-menu. This mode has 2 sub-menus:
4.1) PATCH setup: the
and BANK DOWN
display shows the following:
PROG
display as shown above means
BANK UP and BANK DOWN
display and the active LED will be flashing.
EDIT, COPY, SETUP
(Please see Programming Mode Entry section)
BANK/PROGRAM
PEAK FCB8N: Programmable MIDI foot controller
switches together and hold on until the
"Programming Mode"
switches.
and EXP. You can exit from programming
CANCEL
SETUP switch, the BANK/PROGRAM
StUP
SETUP LED will be flashing. This means you
NEXT>> to see the next sub-menu or
display will show the following:
PrSt
)
switch.
display will
MENU switch.
Page 8 of 16