Edit Mode - Peak FCB8N Owner's Manual

A5.CH: MIDI Channel for 5
A5.CC: Control Change Number (CC#) for 5
Range: 01127
A6.CH: MIDI Channel for 6
A6.CC: Control Change Number (CC#) for 6
Range: 01127
A7.CH: MIDI Channel for 7
A7.CC: Control Change Number (CC#) for 7
Range: 01127
A8.CH: MIDI Channel for 8
A8.CC: Control Change Number (CC#) for 8
Range: 01127
5. To save, press the
FCB8N will return to operating mode.

Edit Mode

On power-up the FC8BN defaults to operating mode. To change to edit mode:
1. Select the PATCH you want to edit.
2. Enter Programming Mode.
3. Press the EDIT
4. All Programming Menu LED's will be off and the
are in Edit mode. To see associated sub-menus please press and hold
5. Scroll up and down the sub-menus by pressing
<<PREV to see previous sub-menu.
th
Global Control Change Message. Range: 0116
th
Global Control Change Message. Range: 0116
th
Global Control Change Message. Range: 0116
th
Global Control Change Message. Range: 0116
SAVE switch, or to exit without saving press the
(Please see Programming Mode Entry section)
switch, the BANK/PROGRAM
Edit
P1.CH
P2.CH
P3.CH
CC.CH
C1.CC
C2.CC
C3.CC
C4.CC
C5.CC
PEAK FCB8N: Programmable MIDI foot controller
th
Global Control Change Message.
th
Global Control Change Message.
th
Global Control Change Message.
th
Global Control Change Message.
display will show the following:
EDIT LED will be flashing. This means you
NEXT>> to see the next sub-menu or
P1.PC
 
P2.PC
 
P3.PC
 

C1.dt
 
C2.dt
 
C3.dt
 
C4.dt
 
C5.dt
 
CANCEL switch. The
MENU switch.
Page 10 of 16