Back Panel - Peak FCB8N Owner's Manual

BANK UP/DOWN SWITCH:
PATCH SWITCHES:
BANK/PROGRAM DISPLAY:

Back Panel

MIDI OUT:
9-12V DC/AC In:
EXP1:
Note: Do not apply power to the external power supply socket if you are phantom powering the unit via
MIDI a cable.
PEAK FCB8N: Programmable MIDI foot controller
Increments and decrements the BANK selection. In 4Pr mode Banks are
numbered from #1 to #32. In 12Pr mode they are numbered from #1 to
#10
In 4Pr mode the FCB8N has 4 Patches in each BANK labelled as P1, P2,
P3 and P4 or 12 Patches per BANK labelled as
mode. These switches are also used for INSTANT ACCESS Commands
and in edit mode for function selection i.e. edit, enter, save, cancel,
copy, etc...
The seven segment display has 4 digits displaying mode when editing a
program or BANK number when in operating mode.
The MIDI out port is used to transmit MIDI messages from the unit to
other MIDI device/s. It is a 7 pin MIDI connector with phantom power
support on pins 6 & 7. Supplied voltage must be within 9V – 12V DC or
12VAC, at 200mA minimum current.
will damage the unit.
Power supply input, 5.5mm/2.1mm barrel connector, Supplied voltage
must be within 9Vdc – 12Vdc or 12Vac, at 100mA minimum current.
Voltage over 12Vdc or 9Vac will damage the unit.
¼" (6.35mm) TRS (Tip, Ring, Sleeve) input to suit standard 10K
expression pedal or volume pedal.
1, 2, 3, ..., 12
Voltage over 12VDC or 9VAC
Page 4 of 16
in 12Pr