Copy Mode - Peak FCB8N Owner's Manual

 4Pr Mode Range: 0, 127, tAP1, tAP2
 12Pr Mode Range: 0127, t.gLE
6. To save please press
The FCB8N will return to operating mode.

Copy Mode

Copy mode allows you to copy the current PATCH to any other PATCH. All the settings for the PATCH are
copied to the new PATCH. To copy a PATCH:
1. Select the PATCH that you want to copy.
2. Enter to Programming Mode.
3. Press the COPY
3. All Programming Menu LED's will be off and the source PATCH LED will be flashing.
4. If the destination PATCH is in the same BANK as the source PATCH then push the PATCH
switch for the required PATCH twice
If the destination PATCH is in a different BANK, select the required BANK by using the
UP and BANK DOWN
the PATCH switch for the required PATCH.
5. Save the copied PATCH by pressing the
the flashing LED switch.
0, 127: Toggles the value between 0 and 127 on each
successive press of the INSTANT ACCESS switch.
tAP1: Momentary operation sets the value to 127 when switch
is pushed and returns it to 0 when the INSTANT ACCESS
switch is released.
tAP2: Sets the value to 127 when the INSTANT ACCESS switch
is pushed (no action on release).
0127: Sets the value entered when the PATCH is loaded.
t.gLE: Toggles the value between 0 and 127 on each
successive press of the PATCH switch.
SAVE switch or to exit without saving please press
(Please see Programming Mode Entry section)
switch, the BANK/PROGRAM
CoPY
switches (the BANK/PROGRAM
SAVE
PEAK FCB8N: Programmable MIDI foot controller
display will show the following:
display will flash) and then press
switch or exit from COPY mode by pressing
CANCEL switch.
BANK
Page 12 of 16