Installation Of Indoor Unit - Kelvinator KSE88CRC Installation Manual

Installation of indoor unit

Installation of Mounting Plate
1 The mounting plate should be installed horizontally.
As the water tray's outlet for the indoor unit is two-way
type, during installation, the indoor unit should slightly
slant to water tray's outlet for smooth drainage of
condenser water.
2 Fix the mounting plate on the wall with screws.
3 Be sure that the mounting plate has been fixed firmly
enough to withstand about 60kg. Meanwhile, the weight
should be evenly shared by every screw.
Note: All dimensions are in mm.
2.6kW , 3.5kW UNIT:
Ø55
160
5.3kW UNIT:
Above 150mm
from the ceiling
158
159
346
70
81
55
39
90
83 130
6.2 kW, 7.0 kW and 8.8 kW UNITS:
Drill Piping Hole
1 Slant the piping hole on the wall slightly downward to
the outdoor side.
Piping hole Units
2.6 kW, 3.5 kW
( 55)
5.3kW, 6.2 kW, 7.0 kW and 8.8 kW
( 70)
6 Installation instructions Kelvinator Air Conditioning
Ø55
35
80
685 205
575
281
70
55
90
166
94
1048
2 Insert the piping-hole sleeve into the hole to prevent the
connection piping and wiring from being damaged when
passing through the hole.
Indoor Outdoor
Wall pipe
Seal pad
Installation of Drain Hose
1 Connect the drain hose to the outlet pipe of the
indoor unit. Bind the joint with rubber belt.
outlet pipe of
indoor unit drain hose
rubber belt
2 Put the drain hose into insulating tube.
outlet pipe of
drain hose
indoor unit
rubber belt
insulating tube
3 Wrap the insulating tube with wide rubber belt to
prevent the shift of insulating tube. Slant the drain
hose downward slightly for smooth drainage of
condensing water.
rubber belt
outlet pipe of
indoor unit
insulating tube
connected
Note:
The insulating tube should be connected reliably with the
sleeve outside the outlet pipe. The drain hose should be
slanted downward slightly, without distortion, bulge or
fluctuation. Do not put the outlet in the water.
bulge
Ø 55/ Ø 7 0
outlet pipe of
indoor unit
distortion
Flooded