Kioti CK20 Owner's Manual page 111

(1) Hydraulic Oil Filter
3. Remove the oil filter.
4. Place a film of clean transmission fluid
of the rubber seal of the new filter.
5. Tighten the filter firmly until it contacts
the mounting surface. Then tighten the
filter, by hand, an additional half turn
only.
CK20H
196OC31A
(1) HST Oil Filter
6. After the new filter is in place , fill the
transmission up with oil to the upper
line of the oil guage.
7. After running the engine for a few
minutes, stop it and check the oil level
again, add oil to the prescribed level.
8. Make sure that the transmission fluid
doesn't leak through the seal.
IMPORTANT
To prevent serious damage to the
hydraulic system, use only a
KIOTI genuine filter.
PERIODIC SERVICE 12-19
CK20
196OC32A
CK20H
(1) Gauge
(A) Oil level is Acceptable Within this Range.
196OC06A
196OC07A
(2) Oil Filling Plug