Kioti DK50 Owner's Manual page 24

Remote hydraulic control system(if equipped)
- Remote Control Valve Coupler Connecting
and Disconnecting
WA R N I N G
To avoid personal injury :
Stop the engine and relieve pressure before
•
connecting or disconnecting lines.
Do not use your hand to check for leaks.
•
- C o n n e c t i n g
1. Clean both couplers.
2. Remove dust plugs.
3. Insert the implement coupler to the tractor
hydraulic coupler.
4. Pull the implement coupler slightly to make
sure couplers are firmly connected.
- D i s c o n n e c t i n g
1. Lower the implement first to the ground to
release hydraulic pressure in the hoses.
2. Clean the couplers.
3. Relieve pressure by moving hydraulic control
levers with engine shut off. Pull the hose
straight from the hydraulic coupler to release
i t .
4. Clean oil and dust from the coupler, then
replace the dust plugs.
NOTE :
Your local KIOTI Dealer can supply parts to
•
adapt couplers to hydraulic hoses.
- Remote Control Valve Lever
Move the lever up or down and hold. This will
raise or lower the implement. Lever will return to
neutral when released.
I M P O RTANT :
Do not hold the lever in the "pull" or "push"position
•
once the remote cylinder has reached the end of the
s t r o k e, as this will cause oil to flow through the
relief valve. Forcing oil through the relief valve
for extended periods will overheat the oil.
When using the tractor hydraulic system to power
•
front loader, do not operate boom and bucket
cylinders simultaneously.
A
B
1, 2 Remote control valve lever
C
D