Kioti DK50 Owner's Manual page 17

- Hazard Lamp Switch
When a hazard lamp switch is pulled to on position,
the hazard lamps blink.
= P TO switch
The PTO switch must be placed to the "n e u t r a l"
positions before starting the engine. otherwise, the
engine will not start.
I M P O RTANT :
• Always turn the starter switch key to the "OFF"
position. Damage may occur to the electrical
system if the engine is running with the starter
switch off.
- Hour Meter
This meter shows the number of hours the tractor
has been operate at rated engine rpm.
The last digit(white background) indicates 1/10 of an
h o u r. The time in minutes will be shown by
multiplying by six to last digit on white background.
Example 0,1,7,0,1... 170hours 6 minutes used
Moving hand indicates the revolution per minute of
the engine
- Cooling Water Temp. Meter
Wait until Engine is warm enough. Do not operate
tractor before Temp. meter indicates the proper
temperature. Be careful not to exceed cooling water
temperature overheated(red mark on Temp. meter)
Before operating tractor, always check the amount
of cooling water in the radiator.
- Engine Oil Pressure Lamp
The oil pressure lamp will glow red when the starter
switch is turned on. This indicates the light and
electrical wiring are functioning properly. The light
should go out after engine starts. If light remains on,
stop engine and determine cause.
- Battery Charge Lamp
The battery charge lamp will glow red when the
main switch is turned on and should go out as
engine starts. If the lamp continues to glow above
idle speeds, the battery is being discharged,
indicating the electrical system should be checked.