Memo - Bentel Security Kyo 320 User Manual

2. Press the ENTER key to select the required Code.
Code 001
Active
3. Press the ENTER key again, the display will show the
following message:
Enter new PIN
PIN ******
4. Enter the new PIN (4 to 6 digits) — * will replace X
as you enter the new digits.
5. Press the ENTER key, the display will show the follo-
wing message:
Repeat new PIN
PIN ******
In the example above, two digits have been entered.
6. Enter the new PIN again, the press the ENTER key to
confirm and go back to step 1.
If necessary, press the ESC: key to abandon the proce-
dure and go back to step 1.
+
You cannot assign the default PIN of one code to
another Code (refer to Table 9).
If you attempt to assign the default PIN of one Code to
another Code, the display will show the following mes-
sage:
Repeat new PIN
Invalid code!
+
You cannot assign a PIN that already exists on the
system.
If you attempt to assign a PIN that has already been as-
signed to another Code, the display will show the follo-
wing message:
Repeat new PIN
Duplicated PIN!
This message indicates that the PIN already exists on
the system, therefore, the Control panel will consider
the Code to be "Disclosed" and, for security reasons,
will automatically restore the default PIN of the Code
concerned.
If a User attempts to access the system using a "Disclo-
sed" PIN, the display will show the following message:
17:05 26/08/2002
Disclosed_PIN!
Disclosed" PINs (at default) must be reprogrammed
(refer to Table 7).
"Disclosed" PINs will be signalled by:
Ø the G LED (ON) on the Keypad
14
Ø the Disclosed PIN! message in View Trouble
mode
Øthe Event details in the Logger
TYPE = Disclosed PIN
IDENT. = the Keypad used
TIME = Time and Date of the Event
The Trouble status will clear when a New PIN (other
than the default PIN) is assigned to the Code with "Di-
sclosed" PIN status.
n Memo
This command will allow you to record and play voice
memos. This command must be enabled on Installer
Menu-Program Panel-Configuration-Keypad-Memo.
USER MENU

Memo

Press ENTER:
Memo
Record message
+
This option must be duly programmed by the Instal-
ler, (Message n.63 only- Quality and Length must
be programmed on Installer Menu-Program Pa-
nel-Voice Messages) otherwise it will not be availa-
ble on the Keypad.
To record voice memos
1. Press ENTER to start recording.
Memo
RemainingSec.030
The numbers on the second line of the display will indi-
cate the remaining seconds before the end of message.
The Green M LED on the Keypad will turn ON to indica-
te that there is a new memo.
To play voice memos
1.Press A or B to display Play message:
Memo
Play message
2. Press ENTER to play the voice memo:
Memo
RemainingSec.030
The numbers on the second line of the display will indi-
cate the remaining seconds before the end of message.
The Green M LED on the Keypad will turn OFF to indi-
cate that there are no unplayed memos.
+
You cannot record a new message until the current
message has been played.
KYO320