Table of Contents
Advertisement
15
Step
Connect
Electrical
(For direct
connection to
house wiring)
16
Step
Secure
Dishwasher
to Countertop
17
Step
Reinstall
Chassis Cover
Verify that power is turned off at source.
WARNING
CAUTION
If house wiring is not 2-wire with a
ground wire, a ground must be
provided by the installer.
When house wiring is aluminum,
be sure to use U.L. approved anti-
oxidant compound and alumi-
num-to-copper connectors.
• Remove the screw holding the junction
box to the dishwasher frame. Remove the
junction box.
• Install a strain relief onto the junction box.
• Tighten the strain relief against the incoming
wires.
• Strip 1/2" insulation from end of wires.
• Connect incoming wires to dishwasher wires
using wire nuts of appropriate size. Connect
white to white, black to black and incoming
ground to green wire.
• Push all wires into the junction box and place
on dishwasher frame. Secure with screw.
To maintain dishwasher position and align-
ment, drill pilot holes through the mounting
flange and into the underside of the
countertop. Install 2 screws provided.
Note: Open and close dishwasher door to
insure proper clearance between tub and
door. If there is any binding or rubbing,
readjust leveling legs.
• To reinstall the plastic chassis cover, tilt and
rotate the cover under the door. Press the
bottom of the cover against the metal frame
of the dishwasher until it fits into position.
• Secure the cover to the dishwasher using the
the two screws with attached spacers.
NOTE: The small
ring of the spacer
goes against the
chassis cover.
Installation
Stainless Steel Interior Dishwashers
Screw
20
Advertisement
Table of Contents
