Tub And Structure; Tub Trim (Some Models); Toe Kick; Junction Box And House Wiring Connection - GE DDT595SxJ0 Series Technical Service Manual

The Tub and Structure section of this guide will
cover the toe kick, junction box, racks, leveling,
door balance, gaskets, trim (some models), main
control board, door, door components, as well
as the removing and separation of the screwless
appearance door. It will also cover the sump module
and removal. Details of the sump components
will be covered in the Circulation System or Drain
System sections of this guide.

Tub Trim (some models)

Some models include tub trim which clips to the
plastic tub to reduce sound levels and provides a
cleaner appearance to the installation.
Tub Trim
If the cutout prevents the dishwasher from being
fully installed, or if the trim rolls inward preventing
properly. The wiper edge must contact the cabinet
WARNING: GE Factory Service Technicians are
REQUIRED to follow Lockout / Tagout (LOTO) 6
Step Process prior to beginning repair.

Tub and Structure

The toe kick panel is a safety and decorative panel
covering the machine area of the dishwasher. The
the dishwasher machine compartment. To remove
the panel, remove two 1/4 in. hex head screws and
The junction box is located behind the toe kick on
the right hand side of the dishwasher. The junction
the dishwasher. The dishwasher may be hardwired
or an optional cord may be installed (available
a wall outlet and connects to the harness plug into
the control (see the Installation Guide provided with
the appliance). The cover is held in place with a 1/4
and pull out and to left to release the tab. It is helpful
to squeeze the top and bottom of the box when
Trim if needed
– 19 –

Toe Kick

panel provides a safety barrier, closing the front of
pull the panel away from the dishwasher.
Insulation Toe Kick Toe Kick Screws

Junction Box and House Wiring Connection

box is where the 120 VAC house voltage connects to
separately, Part #: WX09X70910), which plugs into
in. hex head screw on the left side, and tab on the
right side. To remove the cover, remove the screw
removing and installing.
Toe Kick
Insulation
Junction Box
Mounting Screw
Ground Screws
Junction Box