Table of Contents
Advertisement
13
The water supply line should be flushed to
clear any foreign material before connecting
to the dishwasher.
Step
• Make sure there are no sharp bends or kinks
which could restrict the water flow.
Connect
• Connect the water supply line to the 90°
Water Line
elbow.
• Turn on the water supply and check for
leaks.
14
Follow all local codes and
ordinances.
Step
Drain Line Preparation
• The dishwasher is supplied with a
Install
78" long corrugated drain hose.
Drain
The molded end is designed to fit
5/8", 3/4" or 1" diameter connec-
Line
tions to the air gap, waste tee or
disposer. Cut on premarked line as
required for your installation.
Note: Do not cut corrugated portion
of hose.
1"
• If the location requires a longer
drain hose, add up to 42" length to
the supplied hose. Use 5/8" inside
diameter hose and thin wall copper
coupler to join the hose ends.
Note: Total drain hose length must
not exceed 10 feet for proper drain
operation.
Drain Line Installation
• Connect drain line to air gap, waste
tee or disposer using either
Method 1 or Method 2 as previ-
ously determined.
• Secure connection using appropri-
ate clamps (not supplied).
• Make sure drain hose is not
kinked.
Cutting Lines
3/4"
5/8"
Do not cut corrugated
portion of hose
Installation
Stainless Steel Interior Dishwashers
Method 1–High drain loop with waste tee or disposer
Fasten to underside
of countertop
32"
Min.
18"
Min.
Waste tee installation
Note: Be sure to remove drain plug from disposer before
attaching drain line. Dishwasher will not drain if plug is
left in place.
Method 2–Air gap with waste tee or disposer
Waste tee installation
90° Elbow
Hot Water
Supply
Fasten to underside
of countertop
32"
18"
Min.
Min.
Disposer Installation
Disposer Installation
19
Advertisement
Table of Contents
