Table of Contents
Advertisement
1.
Fit the ceramic rear wall into the bracket at the
back of the firebox .See figure 4.
2.
Place the rear base coal in the firebox. It should
rest on the ledges at the sides and back of the firebox
and its rear face should touch the rear ceramic wall.
See figure 5.
3.
Place the front base coal in the firebox with its
bottom front locating over the front rim of the
firebox. Pull the coal forward so that it locates
immediately behind the front rim of the
firebox. See figure 6.
There are two types of loose coals. These are
identified with the letter "A" or "B" on the
underside of the coal.
There are three "A" coals and two "B" coals.
The position of the loose coals is important.
Do not alter the position of the loose coals
from that shown in this section of the
Owner's guide.
OWNER'S GUIDE
R E F I T T I N G C O A L S
Page 10
Figure 4. Ceramic Rear Wall
Position
Figure 5. Rear Base Coal
Position
Figure 6. Front Base Coal
Position
Advertisement
Table of Contents
