Table of Contents
Advertisement
8.
Place the remaining type "A"
coal between the front and rear
base coals. The letter "A" should
be upside down with its rear face
between the right and centre coals
of the rear base coal. Angle the
coal so that the gap between it and
the type "B" coal to its right is
appreciably larger than the gap
between it and the type "A" coal to
its left but do not have it touching the type "A" coal. This will give the best flame effect.
See figure 11.
Regular maintenance
In order to achieve and maintain high levels of personal safety and performance
efficiency, it is essential that the opening at the back of the fire and the flue are kept clear
of any form of obstruction. It is possible that deposits of mortar or soot could fall and
accumulate causing the flue to be blocked or restricted and so preventing proper
clearance of dangerous exhaust fumes.
In the United Kingdom it is the law that a landlord must have any gas appliance, flue and
pipework which is situated in a tenant's premises checked for safety at least every twelve
months by a competent person (In the U.K, a CORGI registered installer).
We recommend that all gas appliances and their flues, wherever situated, are checked
annually.
Servicing
• In the United Kingdom servicing can be carried out either by a Valor Service engineer
or a CORGI registered installer.
• If you require your fire to be serviced, please contact Valor Service on 08706 090
081 and quote the following details;
a) Model name and number.
b) Appliance serial no. (To be found on a tied label next to the control knob. It is
visible when the bottom front cover is removed.)
If you wish to replace any of the owner replaceable parts listed below, please contact
Valor Spares on 08706 000 454 for your nearest stockist of these parts. When ordering
please quote the part number shown below.
OWNER'S GUIDE
Figure 11.
M A I N T E N A N C E
Page 12
Advertisement
Table of Contents
