Epson Stylus COLOR 440 Service Manual page 113

EPSON Stylus COLOR 440, 640, and 740
4.2.4.5.2 Stylus COLOR 440 and 640
NOTE: These instructions apply to the Stylus COLOR 440 and
640. See the previous page for the 740.
1. Remove the housing. (Refer to
2. Remove the left front panel. (Refer to
3. Remove the waste ink pad assembly. (Refer to
4. Remove the board assembly (see
the PF motor connector (CN7) from the main board.
5. Remove the 2 screws securing the PF motor to the frame. (See
Figure 4-14.) Slide the PF motor toward the front of the printer so
that the motor's pinion gear aligns with the larger hole in the frame,
and remove the PF motor. (See
Handle all the gears carefully, as you would a bearing
C A U T I O N
surface; do not damage or mar the teeth and grooves of
the gears.
During reassembly, be sure to route the PF motor cable
C H E C K
P O I N T
through the right cable hook and the right cable holder, as
seen from the rear (see
Section 4.2.1.)
Section 4.2.3.)
Section 4.2.4.2.)
Section 4.2.2). Then disconnect
Figure 4-13.)
Figure 4-3).
Chapter 4 Disassembly and Assembly
Figure 4-14. Removing the PF Motor Assembly
(Stylus COLOR 440, 640)
104