Epson Stylus COLOR 440 Service Manual page 133

EPSON Stylus COLOR 440, 640, and 740
5.2.2.3.2 Setting the CG Table
C A U T I O N
This section applies only to the Stylus COLOR 740.
There are two models for the Stylus Color 740: the standard model and
the NLSP (world) model. Therefore, you must set the character
generation (CG) table to NLSP or standard as described below.
1. After you've selected NO on the model name confirmation screen
(Figure 5-6), the screen below appears.
Figure 5-11. Destination Selection Screen (Stylus COLOR 740 only)
2. Perform one of the following:

If your Stylus COLOR 740 supports NLSP characters (see the
caution note below), select NLSP.

If your Stylus COLOR 740 does not support NLSP characters,
select Standard.
After a few seconds, the program automatically returns to the model
name confirmation screen (Figure
The CG table has been correctly set. Return to
Section 5.2.2.3 to enter the main menu.
C A U T I O N
If the main board is a replacement board, its CG table
has been set to Standard at the factory and may need
to be changed to NLSP. However, you should not
select NLSP if the new board does not support NLSP
characters. You can distinguish the NLSP model from
the Standard model by looking at the main board itself:

Standard: The space for IC6 is vacant on the main
board.

NLSP: IC6 is built into the main board.
Chapter 5 Adjustments
5-7).
Step 1
of
124