Accessing The Switch Through The Serial-Port Interface - Lenovo SI4093 User Manual

Accessing the Switch Through the Serial-Port Interface

1. Connect one end of the specifically designed serial cable that comes with your
2. On the management station, open a console window and make sure that the serial
3. When prompted, enter your user name and password.
42
SI4093 System Interconnect Module User's Guide
The serial port provides basic communication RS-232 serial-data transfer through a
terminal emulation program (such as Hyperterminal). Because messages from the
power-on self-test (POST) and all initialization information are transmitted
through the serial port, you can use the serial port to log in to the switch and access
and configure the internal switching firmware.
To log in to the switch, complete the following steps:
device into the RS-232 port and connect the other end to the management station.
For additional information, see
page 23.
port is configured with the following settings:
9600 baud

8 data bits

No parity

1 stop bit

No flow control

When logging in to a switch for the first time, the default switch administrator

user name is USERID, and the default password is PASSW0RD (where the sixth
character is the number zero, not the letter O). The User ID and password fields
are case-sensitive. For security purposes, you will be prompted to change the
administrator password after the first successful login.
Otherwise, if you have an assigned user account, use your assigned user

name and password.
The serial port is compatible with the standard 16550 Universal Asynchronous
Receiver/Transmitter (UART) protocol. The RS-232 serial port is enabled by
default.
"Connecting the Serial Console Cable" on