Lenovo SI4093 User Manual page 30

1. Remove the protective caps from the end of the fiber optic cable.
2. Gently slide the fiber optic cable into the QSFP+ module until it clicks into place.
3. Check the LEDs on the switch. When the switch is operating correctly, the green
Disconnecting a Fiber Optic Cable
1. Squeeze the release tabs and gently pull the fiber optic cable from the module.
2. Replace the protective caps on the ends of the fiber optic cable.
Removing a QSFP+ Module
1. Read the safety information that begins on
2. Read the information in
3. Remove the fiber optic cable from the module that you want to replace. For more
30
SI4093 System Interconnect Module User's Guide
To connect the fiber optic cable to the QSFP+ module, complete the following steps.
link LED is lit. For information about the status of the switch LEDs, see
the Information Panels, LEDs, and External Ports" on page
To disconnect the fiber optic cable from the QSFP+ module, complete the following
steps:
To remove the QSFP+ module from the switch port, complete the following steps.
page 18.
information about removing the cable, see
page 30.
Attention: To avoid damage to the cable or the module, make sure that you
disconnect the fiber-optic cable before you remove the QSFP+ module from the
switch port.
Fiber-optic
cable
page 5
"Handling Transceiver Modules" on page
"Disconnecting a Fiber Optic Cable" on
Protective cap
"Locating
32.
and "Installation Guidelines" on
25.