Vigitron Vi3010 Installation And Getting Started Manual page 20

10 port series poe+ l2 plus managed switch
Hide thumbs Also See for Vi3010:
Table of Contents

Advertisement

Connecting to a
Power Source
To Install a SFP Transceiver, Do the Following:
Step1. Consider the network and cabling requirements to select an appropriate SFP
transceiver type.
Step2. Insert the transceiver with the optical connector facing outward and the slot
connector facing down. Note that SFP transceivers are keyed so they can only be
installed in one orientation.
Step3. Slide the SFP transceiver into the slot until it clicks into place.
You can plug or remove the power cord from the AC power socket to switch the
power on and off.
Figure 13: Inserting the Power Cord to AC Power Socket
Step1. Insert the power cable plug directly into the AC socket located at the back of
the switch.
Step2. Plug the other end of the cable into a grounded 3-Pin AC power source.
Step3. Check the front-panel LEDs as the device is powered on to be sure the
POWER LED is lit. If not, check that the power cable is correctly plugged in.
WARNING:
the AC line cord. You must use a line cord set that has been
approved for the socket type in your country.
NOTE:
SFP transceivers are not provided in the switch
package.
For international use, you may need to change
20

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Vi3010 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents