Mounting The Frame - Gamma 5003 Owner's Manual

ASSEMBLY INSTRUCTIONS
Racquet Supports closer to the inside surface of the racquet at the head and throat. Turning
the knobs in the opposite direction will move the Mounting Stands closer together and will
allow the Racquet Supports to move away from the racquet frame.

MOUNTING THE FRAME

Adjusting the Inner Racquet Supports
The white racquet supports are adjustable to accommodate
all racquets and provide maximum support to the racquet
frame. Screw the pads up or down so they contact the
frame at a maximum height without blocking the grommet
holes.
Height Adjustment
The turntable height can be adjusted to suit
the stringer. To adjust, loosen the two set
screws on the lower column support post be-
low the bellows assembly. Adjust the amount
of engagement between the upper and lower
column supports until the desired height is
attained. Make sure that the tension track is
still aligned with the long leg of the base and
tighten the two set screws to lock the upper
support column into place.
Mounting Stand Adjustment
When mounting a racquet, adjust the
Mounting Stands so that the white Racquet
Supports on top of the Mounting Stands fi t
inside the hoop of the racquet. Lower the
racquet over the Racquet Supports and ad-
just the Mounting Stands until the supports
just make contact with the inside surface of
the racquet at the head and throat. There is
an arrow on the face of each knob indicat-
ing the turning direction that will "Tighten"
the mounting points by moving the 2pt
Mounting Stands further apart to bring the
8