Gamma 5003 Owner's Manual page 6

ASSEMBLY INSTRUCTIONS
Bellows Installation
The bellows assembly is supplied in two
pieces and should be assembled as follows.
Place the bellows section with the fl ange over
the upper support column with the fl ange on
the top. Place the remaining bellows over
the upper support column and mate it with
the fl ange on the lower bellows.
Tool Tray Installation
Lower the tool tray over the top of the upper
column support and let it rest loosely on the
bellows assembly.
Tension Track Installation
Place the tube of the tension track assembly
over the top of the upper column support and
align the tension track with the long leg of the
base. Securely tighten the two socket set
screws on the tension track assembly tube,
locking it to the upper column support. Align
the notch in the tool tray with the tension
track bar while raising the tool tray. Secure
the tray with the set screws in the side of
the tray casting.
6