Troubleshooting Tips - Gamma 5003 Owner's Manual

2 point sc mounting
Hide thumbs Also See for 5003:
Table of Contents

Advertisement

Periodically clean the hold down clamp pin using rubbing alcohol to remove residue or dirt,
that may build up over time.

TROUBLESHOOTING TIPS

PROBLEM
String slips in clamps
String slips in gripper
String clamp base slips on turntable
String tension too tight or too loose
With time and use, the clamping surfaces of your machine may become oily or dirty and result
in string or clamp slippage while stringing. Periodic cleaning of the String Clamps, String Clamp
Base and String Gripper is recommended. Knife sharpening stones work well for cleaning the
diamond coated string clamping surfaces. Cleaning with a solvent such as isopropyl alcohol
and a mild abrasive tool such as a toothbrush also works well to remove oily or greasy build up.
CARE & CLEANING
2pt Hold Down Clamp Adjustment
The 2pt hold down clamps have been ad-
justed at the factory. However, depending on
the racquet frame thickness, the hold down
clamp may require adjustment. Use a 3 mm
hex wrench and turn the set screw clockwise
to reduce the hold down clamp pressure and
counter clockwise to increase the hold down
clamp pressure.
Note: To avoid potential damage to the rac-
quet only make small adjustments at a time
by slightly turning the set screw by no more
than 1/4 of a turn. Test the hold down lever
to insure the racquet is held snuggly but
without applying excessive force to the lever.
SOLUTION
- Adjust gap between clamp jaws
- Clean clamp jaws
- Adjust gripper jaw stop screw
- Clean gripper jaws
- Clean bottom of clamp & top of turntable with
alcohol
- Adjust clamp base locking nut
- Check tension using a tension calibrator,
adjust machine calibration if necessary
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

6004

Table of Contents