On/Off; Using Your Keypad; Focusing; Mounting On A Tripod - ATN BinoX 4T Series Manual

ON/OFF

stops responding to the control panel. Press and hold the Power button for 15
seconds to reboot the binocular.

USING YOUR KEYPAD

Menu. You can quickly choose Exit Shortcut from any position. Use the
down arrow button from any menu screen to exit to the Home Screen by
pressing and holding down the rearmost down arrow for a few seconds.

FOCUSING

DIOPTER ADJUSTMENT
By rotating the Diopter Adjustment Ring you will achieve optimal sharpness
DIOPTER
ADJUSTMENT
RING
FOCUS
ADJUSTMENT RING
8
To TURN ON the device,
press and hold the POWER
button until you see the ATN
splash screen.
To TURN OFF the device,
press and hold the POWER
button, until "Shut down the
device?" appears in the dia-
log box. Choose "Yes" to turn
off.
If the binocular freezes or
The KEYPAD is programmed to be used
in two different ways.
• Short and Quick Taps — used for most
functions and to get around the menu.
• Press and Hold — designed to be used
in the following situations — ON/OFF,
SHORTCUT MENU.
• You can use the forward and rearward
keys (zoom keys), while in the System
Menu, as UP and DOWN buttons.
NOTE
Using LEFT or RIGHT buttons in the
for your vision. Look through the eyepiece
while focusing on the reticle and widgets
on the screen.
NOTE
Once the Diopter Adjustment is set to
your liking, adjustment will not need to
be performed unless another user al-
tered the focus for their needs.
DISTANCE FOCUS
Rotate the Adjustment Ring, as neces-
sary, to achieve the proper focus at vari-
ous distances.
INTERPUPILLARY ADJUSTMENT
Each eyepiece moves laterally to adjust for interpupillary spacing.
MOUNTING
ON A TRIPOD
The BinoX 4T is tripod mount-
able and can be mounted on tri-
pods with a 1/4" thread mount.

COMPASS CALIBRATION

When the compass needs to
be calibrated the word "CAL" ap-
pears instead of the Compass
Scale. To calibrate you should ro-
tate the device on three axis as
pictured on the right.
NOTE
After calibrating the device
please remember that the com-
pass will work best when hold-
ing the BinoX 4T parallel to the
ground.
Other possible abbreviations:
• ERR — an error was detect-
ed;
• SMF — your device is under Strong Magnetic Field;
• UPD — your firmware needs to be updated.
9