Troubleshooting; Troubleshooting On Error Led Display - Fujitsu PRIMERGY SX10 S2 User Manual

5

Troubleshooting

This section explains the procedures when this product is not running properly.
If the problem is not resolved after performing the following troubleshooting, con-
tact an office listed in "Appendix B Contact Information" ( p.90) referring to
"5.3 Contacting Maintenance Support"( p.85).
5.1

Troubleshooting on Error LED Display

LED status
On (amber)
Blinking (amber): fast
(one second interval)
Blinking (amber): slow
(two seconds interval)
78
Status
Temperature Check that the temperature around this product's
abnormality was installation location is correct (10°C to 35°C).
detected. If it is correct, this product may fail.
Contact an office listed in "Appendix B Contact
Information" ( p.90)
The voltage Check the voltage switch setting. If the voltage
switch setting is switch setting is wrong, remove the power cable
wrong or a fan and correct the setting.
error was "4.2 Connecting the Power Cable"(p.76)
detected. If the LED is still blinking even after correcting
the setting, this product may fail.
Contact an office listed in "Appendix B Contact
Information" ( p.90)
Action