Rear; Power Connector - Fujitsu PRIMERGY SX10 S2 User Manual

1.2

Rear

2. SCSI INPUT connector
1 Lock lever
Slide these levers when removing the top cover.
2 SCSI INPUT connector
A SCSI cable is plugged in to connect the server.
3 Voltage switch (115V/230V)
The voltage setting differs depending on your country's standard.
The voltage is set to 230V in default.

4 Power connector

A power cable is plugged in.
5 Release tie
Use this release tie to secure the power cable to prevent it from falling.
54
1. Lock levers
3. Voltage switch
5. Release tie
The power supply of this server is 100–240 VAC. Use a power cable that
meets your country's standard. For details, refer to the "Appendix A Power
Cable Selection" ( p.87).
4. Power connector