Fujitsu PRIMERGY SX10 S2 User Manual page 77

2
Connect the power cable to the power connector.
Install wiring leaving plenty of slack for when operating this product while it is
pulled out from the rack. Use the release tie to secure the cables that were
connected to prevent them from falling.
After connecting the power cable to this
product, refer to the figure below, and
secure the power cable with the release
tie. When unplugging this product's
cable, make sure to unplug the
connector on this product end.
Power cable
After connecting the peripheral devices, tie all the cables and fix them with the
release tie to the cable holder provided with the rack.
This forming process makes the cables easily recognizable even when multiple
servers are installed in the rack.
[Rear side of the rack]
Release tie
Make the circle by
passing tie ahead in the
box. Afterwards, tighten
by pulling it.
Release tie
Cable holder
Cables
4 Connecting Cables
E
77