Fujitsu PRIMERGY SX10 S2 User Manual page 84

The backup unit cannot be recognized from the server.
What is the status of the Power LED?
The target backup unit is turned
on?
The drive SCSI ID setting is
correct?
(1) The server SCSI card is
recognized correctly?
(2) The Term Power setting is
correct?
The SCSI cable (for server
connection) is connected correctly?
The SCSI cable (for server
connection) is come down?
The SCSI connector between
the I/O module and drive bay is
connected correctly?
The termination resistor is
connected correctly?
The SCSI cable between the I/O
module and drive bay is come
down?
This product may fail.
Contact maintenance support.
84
Off
Lit up amber
Lit up green
Blinking green
No No
No No
No No
No No
No No
No No
No No
Refer to the following according to the
power switch setting.
- "Even when the power switch is set to
"|", the power cannot be turned on." (p.79)
- "Even when the power switch is set to "R",
the power cannot be turned on." (p.81)
Deal with this problem referring to "The backup unit
cannot be turned on." (p.83)
Refer to each backup unit's manual for the setting,
and set it correctly.
(1) Refer to "Troubleshooting" in
the server or SCSI card's manual.
(2) Refer to each backup unit's manual
for the setting, and check that the
Term Power setting is correct.
Connect it properly.
"4.1 Connecting the SCSI Cable
for the Server" (p.75)
Contact maintenance support.
Connect it properly.
"2. Installing Internal Options" (p.56)
Contact maintenance support.