Install Guide Rails And Wiring Connectors - Emerson Micro Motion 3500 Installation Manual

1.4

Install guide rails and wiring connectors

1.4.1 Guide rails
Positions of guide rails and wiring connectors are indicated in
rails should be 27 HP (27 TE) apart, for example, at 1 HP (TE) and 28 HP (TE).
1.4.2 Wiring connectors
The applications platform is shipped with the following equipment:
Model type
Model 3300
Model 3500
1. Working from the front of the rack, use the supplied M2.5x8 screws to install the
wiring connectors onto the back of the rack.
•
•
2. Use the centers of the guide rails as reference points and refer to
Guide rail centers should be 27 HP (27 TE) apart; for example, 1 HP (1 TE) and 28 HP
(28 TE).
3. Install the input/output wiring connector at 4 HP (4 TE) from the neighboring unit or
from the edge of the rack.
4. (Model 3500 only) Install the keyed sensor wiring connector at 16 HP (16 TE) from the
neighboring unit or from the edge of the rack.
5. Install the power supply wiring connector at 25 HP (25 TE) from the neighboring unit
or from the edge of the rack.
Installation Manual
Equipment
• A solder-tail or screw-type connector for input/output wiring
• A plug-in connector for power-supply wiring
• A screw-type connector for input/output wiring
• A screw-type connector for sensor wiring
• A plug-in connector for power-supply wiring
The Model 3500 has six M2.5x8 screws and three connectors
The Model 3300 has four M2.5x8 screws
Planning
Figure 1-5. Centers of guide
Figure 1-5.
9